12V 100 amp Hour Lithium Ion Pack for solar or wind energy storage

12V 100 amp Hour Lithium Ion Pack for energy storage Specific Energy:110Wh/Kg Volumetric Specific Energy:162 Wh/L CE,UN38.3

12V 100 amp Hour Lithium Ion Pack for solar or wind energy storage

3.2V 100AH LiFePO4 battery module spec sheet

Item No.	Voltage	Capacity	battery type	Lifespan	Impedance	Specific Energy	Dimensions	Weight
GPLFP46182295/100Ah	3.2v	100AH	LiFePO4	>2000 cycles	< 0.5 mΩ	110Wh/Kg	46*182*295mm	3.3kgs

12v 100 amp hour lithium ion pack Advantage

a. Extremely safe and stable chemistry.

b. Long life-cycle: Can be circularly used, more than 2000 times recycles, 8 times of Lead acid battery.

c. Lighter weight, with the best power-to-weight ratio: 1/3 of Lead acid battery weight.

d. Good performance at high temperature and high temperature resistance

e. Low self-discharge rate, less than 3% monthly.

f. No memory effects and highly efficient charge.

g. Environment friendly: Clean and Green energy poses no pollution on our environment.

Characteristics

1. Soft polymer pack, no need for safety valve;

2. With reduced electrolyte,further enhancing battery safety and being able to be positioned in any direction;

3. Low internal resistance,less than 0.5 mΩ

4. Flexible design to meet customer's unique requirement;

5. Basic cells are mass produced and easy to build stable and consistent large capacity battery packs;

6. Suitable for high rate charge and discharge.

Battery Performance

1.Electrical characteristics

NO.	Item	Requirements	Test Method
1	Dischargerateperformance	Discharge Capacity/Nominal capacity×100%A) 0.3C5A ≥100%B) 1.5C5A ≥90%	a)Standard charge at 0.3C5A under the condition of normal atmospheric pressure andthe environmental temperature of 20°C±5°C and45%~80% RH, discharge at 1I3/4.5I3(A)to 2.0V or the cut-off voltage which is specified in the technical document of the company.b)the capacity(AH)=the discharge time*discharge current,and then is describedthe percentage of the nominal capacity(Charge/discharge cycle can be conducted for 3times before meeting the Standards(the samebelow).
2	High-lowTemperatureDischargeperformance	Discharge Capacity/Nominal capacity×100%A) 55 °C ≥95%B) -20°C ≥55%	After Standard charging. Then store it at the constant temperature of 55±2°C for 5h(of -20±2°C for 20h),and discharge at 0.3C5A to 2.0V or the cut-off voltage whichis specified in the technical document of the company,thecapacity(AH)=the dischargetime*discharge current,and then is described the percentage of the nominal capacity.
3	NormalStorage/HighTemperatureStorage	Residual Capacity≥Nominalcapacity*80%Recoverable capacity≥Nominal capacity*90%	Store for 28 days(Store for 7 days at the constant temperature of 55±2 °C)afterstandard charge, then measure final status and residual capacity at 0.3 C5A to 2.0Vor the cut-off voltage which is specified in the technical document of thecompany;After charge/discharge(0.3C5A/0.3C5A)cycle can be conducted for 3 times,recoverable capacity will be tested.
4	StoragePerformance	recoverablecapacity ≥nominalcapacity *95%	Standard charge and then rest for 1H,then discharge for 2H at0.3C5A,storge for 90days at 20°C±5°C,After standard charge,then discharge at 0.3C5A,(Charge/dischargecycle can be conducted for 5 times before meeting the Standards(the same below)
5	Cycle Life	Discharge Capacity≥Nominal capacity*80%	Conduct 0.3C5A/0.3C5A cycle for 2000 times.The discharge capacity shall bemeasured after 2000 cycles.

2. Safety Performance

NO.	Item	Requirements	Test Method
1	Over charge	No fire,no explosion	After standard charging,then Charge at 3C5A to 10.0V
2	Over discharge	No fire,no explosion	After standard charging,discharge 0.3C5A to 0V at 20°C±5°C
3	Short Circuit at Room Temperature	No fire,no explosion	After standard charging, keep the battery into a ventilation cabinet and short-circuit the positive and negative terminals directly (general resistance shall be less than or equal to 5mΩ) for 10 minutes
4	Drop	No fire,no explosion,no leakage	After standard charging, then let it self fall off from a height of 1.5m(the lowest height)to a rigid wooden board with the thickness of 20mm. The drop is implemented one time for every face.
5	Hot Oven	No fire,no explosion	After standard charging. Keep the battery in the box with constant temperature of 85°C±2 °C and remained for 2hours at this temperature.
6	Crush	No fire,no explosion	After standard charging, keep the battery on the bracket1. Extrusion direction:Perpendicular to the direction of maintaining pressure on the battery plates.2. Extrusion headdress product:≥20cm3. Extrusion degree: Until the battery shell ruptured or internal short circuit (battery voltage becomes 0V)
7	Needlepunctureperformance	No fire,no explosion	After standard charging, keep the battery on the bracket,penetrate through it with a 3mm~8mm diameter nail near the center of its biggest surface at the rate of 10mm/s-40mm/s.

Battery performance graph

  Why  choose G-Power Battery?

G-Power is a leading hi-tech enterprise combining technical research, development, manufacture and marketing. Specializes in researching, designing and manufacturing lithium ion batteries,LiFePO4 batteries,etc.

Customer Feedback

The batteriess are even better than expected and expectations were very high.----Antonio(from Livorno, Italy)

We are happy with G-Power battery quality. I've also been very happy with your good service, let's continue discussions and work on more.----Michael (from Berlin,Germany)

Order information

Sample is avaliable and welcome.

Trade term: FOB Shenzhen or Guangzhou; EXW, CIF,DDU and DDP are available.

Delivery time: 3 working days for sample order, 15-25 working days for mass order.

Packing info is as below:

Product	Item No.	QTY	Carton box dimensions(mm)			Gross weight(kg)
			Length	Width	Height
100AH Battery module	GPLFP46182295 /100Ah	2	120	240	330	7.2

Warranty

2 years since the date of purchase

Warranty term

1. Under the terms of this warranty, if the product have a failure occurs under normal usage within warranty period, G-Power will provide new products based on the proof-documents.

2. If Failure or damage due to incorrect operation, wire connection, or anything other do not follow our instuction, G-Power will provide paid maintance within warranty period.

More information on our products, pls do not hesitate to inquiry now!

12V 100 amp Hour Lithium Ion Pack for solar or wind energy storage